FT 8110
POINT LEVEL SWITCH
The FT8110 series point level product is a line powered RF Driven Shield "switch" suitable for the most demanding, heavy coating build up applications
- Liquids
- Slurries
- Granulars
- Powders
- Interface Applications
A simple NO moving part design that eliminates mechanical failures and extensive maintenance.
The special Driven Shield technology ignores coatings or "build up" while maintaining the calibration trip point. The FT8110 product line features integral or remote electronics and a wide selection of probes and hazardous area approvals.
PRODUCT SPECIFICATION
| Power Requirements | 180 - 260 VAC 50/60 Hz 95 - 145 VAC 50/60 Hz |
| Output | DPDT (Double pole, Double throw) Form C relay |
| Contact Rating | 250 VAC; 1A Inductive, 3A non inductive |
| Power Consumption | 2 Watts Max |
Load Resistance (Coating rejection) |
0 Ohms CW to BW 10 Ohms CW to Grd |
| Response Time | less than 0.5 seconds |
| Resolution | 2 pF or less |
| Repeatability | <1mm (conductive) <50mm (insulating) |
| Fail safe | High level (HLFS) or Low level (LLFS) |
| Status Indicator | Red - Alarm Green - Normal Yellow - Instrument Failure |
| Housing Operating Conditions | -40 to +70C 100% RH (non condensing) |
| Electronic Housing | IP 67, NEMA 4X |
| Electrical Connections | Dual M20 x 1.5 or 3/4 NPT |
| Process Connections | BSP, NPT (Flange optional) |
| Barrier | IS Limiting circuit for probe |
| Spark Protection | Surge strike less than 1000V at probe |
| RFI | Built in filter, tested per CE mark |
| Approvals | CE ATEX |
| System Rating | EExd (ia) IICT4 |
| Remote Cable Length | 5 metre standard, 50 metre maximum |
| Probe Operating Range | -40 to +815C 0 to 913psi |